If your still facing the problem, send me your mach3 version, your mach3 configuration file and values you modified in your VFD configuration (do not worry about values you do not have modified). Send it to firstname.lastname@example.org and we will understand and solve the problem
The good news is that speed control and start control (F5-including Mxx start commands) work fine. E-stop also works fine with Mach3 Version R3.043.066. This is a fresh installation of Mach3 with only this spindle plugin installed using the instructions provided on your webpage.
When I attempt to load your plugin, I get this error message: « Plugin Dll defective, reload »I have tried several from differant locations and get the same responce. Mach3 version: R3.043.066.Any suggestions?
I can run the spindle manually but really nothing with mach3 i can hear the relay trip on the vfd and if i mess around i can get it to spin for a couple seconds then trips the estoplol i hate to say it but i am stumped
SebastionYour second suggestion was the likely suspect. The usb/485 I had used worked fine on my NEW computer in devices.I had to connect my OLD computer to the internet and download a driver for it that worked. I now have m3,m4,m30 and can program in the speed on mach3. Just a little bit more tweaking and it will be perfect.Thank you Graham 2b1af7f3a8